Narva Motion Activated Led Sensor Light Pir 12V Volt Exterior Lamp Cargo 87792
FAST SECURE SHIPPING * WHITE * WATERPROOF DESIGN
Make 4 payments of $16.49 over 8 weeks and get it now!
1 x GENUINE NARVA 12 VOLT WATERPROOF EXTERIOR LAMP PIR MOTION SENSOR SWITCHED & HIGH OUTPUT L.E.D's MODEL 87792
Narva’s new low profile L.E.D awning lamp’s are ideally suited to modern vans, caravans and motorhome exteriors. Designed with easy installation in mind, the lamps are pre-wired, surface mountable and include a stylish “snap together” housing.Using the latest high output L.E.D’s the lamps feature the benefits of long life performance together with ultra low current draw. Constructed with a virtually unbreakable polycarbonate lens the awning lamps have been designed specifically for a range of exterior applications. If no motion is detected any more the 87792 switches off with a 30 second delay. Ideal in the cargo space of a truck , bus , motorhome , caravan or interior marine application or inside cupboards.
This lamp can be connected a number of ways
1: To use permanently on just connect the Red wire to permanent power and the Black to Earth , the white wire is not connected.
2: To use through a switch only just connect the Red wire to a switched power supply and the Black to Earth , the white wire is not connected.
3: To use through the PIR ( light sensing switch) connect the White wire to permanent power and the Black to Earth , the light will only then work in pitch black conditions so if you are trying to test it in daylight this will not work Red is not connected .
4: To use through the PIR ( light sensing switch) but over ride switchable connect the Red wire to a power supply and White wire also to power supply BUT BOTH THROUGH A TWO WAY SWITCH ( not supplied ) and the Black to Earth , when the switch is then switched to PIR the PIR light will still only then work in pitch black conditions , so if you are still trying to test it in daylight this will not work.
- Virtually unbreakable polycarbonate lens
- Surface mountable with decorative bezel to hide mounting fixtures
- High Output LED's
- 12 volt
- IP66 Rated
- Low current draw
- Dimensions 365mm long , 39mm at the deepest point , 49 mm at the widest point ( see picture )
- 2 fixing screw holes ( with screws included ) 270mm apart
- Wiring exits out the rear of light in the centre
- Detection Angle 60º Horizontal
- Detection Angle 60º Vertical
- Switch off delay :30 Seconds
- white to positive
|Unit Of Measure||ea|
Be The First To Review This Product!
Help other Autoelec users shop smarter by writing reviews for products you have purchased.