Schumacher Smart Battery Charger 12V Car Motorbike Caravan AGM Deep Cycle SLA
FAST SECURE SHIPPING * MAINTENANCE CHARGER
Make 4 payments of $12.25 over 8 weeks and get it now!
GENUINE SCHUMACHER BATTERY CHARGER WITH BATTERY CLAMPS AND EYELET CONNECTOR LEAD MODEL P/N SPI2
Now available in Australia the range of Schumacher battery chargers .The Schumacher SPI2 Battery Charger/ Maintainer. This 6-12Volt Multiprocessor Controlled Charger features an automatic float mode which means this charger will preserve the battery charge without overcharging. This 2 Amp charger can be used for most battery types like AGM, Standard and Gel Cell and is ideal for small batteries for power sport, car and boats. With Auto Voltage detection this charger automatically determines whether the connected battery is a 6 Volt or 12 Volt Battery. This Charger also has Reverse Hook-Up Protection which means the charger will not operate if the clamps are reverse on the battery terminal.
- Charges small batteries and keeps stored lead-acid batteries charged
- Extends battery life ─ up to 2 years longer
- Charges all all types of 12V lead-acid batteries (WET, MF, Ca/Ca, AGM and GEL)
- Battery charging capacity - 6–46Ah and up to 135Ah for maintenance
- Microprocessor controlled ─ multi-stage charging for added precision, safety and battery life
- Float mode monitoring ─ automatically maintains optimum battery charge
- Auto voltage detection ─ 6 or 12 volt batteries
- Quick-connect harness ─ attaches either of the connectors in seconds
- Reverse hook-up protection ─ helps prevent damage to battery and charger
- Hook attachment ─ hang outside the work area, for safety and convenience
- Schumacher SPI2 battery charger/maintainer
- Battery clamp ( aligator ) quick-connect
- Ring connector 6mm quick-connect
- Oowners manual
- Input: 230V AC~50Hz, 0.5A
- Output: 2A @6V 2A@12V
- Dimensions: 193 mm x 84 mm x 78 mm
- Weight: 0.65 kg
- Output protection: Yes
- Reverse polarity protection, spark/arc-proof: Yes
- Ingress Protection rating: IP54
AUTOMATIC CHARGING MODE
When an Automatic Charge is performed, the charger switches to the Maintain Mode automatically after the battery is charged. For a battery with a starting voltage under 1 volt ( overdischarged ) it is recommended to link in pararlell with a fully charged battery of the same voltage to try and raise the voltage above the chargers thrshold start charge voltage.
If charging cannot be completed normally, charging will abort. When charging aborts, the charger’s output is shut off, the yellow/orange CHARGING aborted charge, unplug the charger from the AC outlet, wait a few moments and plug it back in.
If the battery is left discharged for an extended period of time, it could become sulfated and not accept a normal charge. If the charger detects a sulfated battery, the charger will switch to a special mode of operation designed for such batteries. If successful, normal charging will resume after the battery is desulfated. Desulfation could take up to 8 hours. If desulfation fails, charging will abort, and the yellow/orange led will flash .
COMPLETION OF CHARGE
Charge completion is indicated by the green CHARGED LED. When pulsing, the charger has switched to the Maintain Mode of operation.
MAINTAIN MODE (FLOAT-MODE MONITORING)
When the green CHARGED LED is pulsing , the charger has started Maintain Mode. In this mode, the charger keeps the battery fully charged by delivering a small current when necessary.
NOTE: If the charger has to provide its maximum maintain current for a continuous 12 hour period, it will go into Abort Mode (see Aborted Charge section). This is usually caused by a drain on the battery, or the battery could be bad. Make sure there are no loads on the battery. If there are, remove them. If there are none, have the battery checked or replaced.
MAINTAINING A BATTERY
The SPI2 maintains 6 and 12 volt batteries, keeping them at full charge. NOTE: The maintain mode technology allows you to safely charge and maintain a healthy battery for extended periods of time. However, problems with the battery, electrical problems in the vehicle, improper connections or other unanticipated conditions could cause excessive current draws. As such, occasionally monitoring your battery and the charging process is recommended.
*WARRANTY The manufacturer supplies a 2 year warranty nationwide and we provide a further 3 year warranty after this ! This extended warranty is under same terms and conditions as the manufacturer's original 2 year warranty, the only difference is the item will be required to be shipped back to us at the purchasers expense. We can offer this FANTASTIC WARRANTY OFFER because we have a fully equipped technical service facility with qualified tradesmen.
REMEMBER WE OFFER SECURED SHIPPING WITH TRACKING ON THIS LISTING
|Unit Of Measure||ea|
Be The First To Review This Product!
Help other Autoelec users shop smarter by writing reviews for products you have purchased.